The tricone roller bit performs a lot of oil drilling work every day, so it is very susceptible to wear. Many construction units pay little attention to its maintenance, resulting in a very high scrap...
The tricone produced and processed by the tricone bit manufacturer is mainly used in oil drilling. This product can improve the efficiency of oil drilling and at the same time save the cost of drillin...
The precautions for using tricone bit are as follows:1. Tricone bit operates in different rock formations, and chooses different types of drill bits, axial pressure and speed according to the softness...
The tricone roller bit may not have been known to you before. It is a kind of drilling accessory and it has been used for many years. What kind of performance does the drill bit tool have when it is u...
The main rock breaking methods of oil roller bits:When the drill bit is drilled, the weight on the oil roller bit is applied to the rock through the teeth, and there is an impact load in addition to t...
Operation analysis of tricone bit after going down well:(1) When drilling down and encountering an obstructive stroke, the drilling pressure should be controlled below 20KN, and the speed should be le...
1. The function of the tricone bitThe top of the tricone bit adopts diamond compound teeth on the top of the cone to enhance the wear resistance of the teeth and increase the service life of the bit. ...
Diamond bit is a cutting tool which uses diamond material as cutting edgeThe mining drill bit is the main component of the drilling equipment, and its main function is to break the rock and form a bor...
PDC bit is made of polycrystalline diamond cutting blocks, and then a certain number of cutting blocks are mounted (or sintered) on the bit body.The cutting block is sintered into a whole by a thin la...
As a tool for drilling rock formations, rock bits have been widely used. Significant improvements in bit performance have directly reduced drilling costs, especially in the past decade. Service life a...
Water well drill bits can be regarded as the lowest cost drill bit, because we all know that water well drill bits are used in the upper stratum, and the wear on the drill bit is very small, so the ha...
Ⅰ. The common phenomenon of PDC drill bit balling 1. The footage is obviously slower when drilling, or it is obviously higher when drilling;2. Increasing or reducing WOB has no obvious effect on d...
The main parameters of the rock reamer operation control are the push-pull force applied to the reamer by the drilling rig (pull force during reverse reaming, thrust force during forward reaming), or ...
Choosing the suitable under reamers hole openers according to the characteristics of the stratum during construction is the main way to improve construction efficiency.In order to adapt to different f...
Ⅰ. Classification of tooth bitsDrilling, exploration, petroleum, drill bits, drilling accessoriesⅡ. The main structural features of tooth bits:1. The use of high-strength and high-toughness carbide ...
